The track only had a burst propulsion system for the first meter of the track. The Inductrack method was created, tested, and proven to work on a small scale level with a 20 meter track. Department of Energy that was demonstrated in 1998. Post, Physicist at Lawrence Livermore National Laboratory, was the creator and team leader of the first Inductrack developed under the U.S. We can make modifications in to this maglev train project and make it more automatic and user friendly.Richard F. The Maglev Train project is very interesting DIY project for a student or a hobbyist and it can be used in science exhibitions too. For that you can use a propeller or motor with fan etc. The other method is to make a force on any side of the train to drive it to forward. Mainly there are two ways to run the train, one way is to seize anything on the ground and push or pull forwards, tilting the rail etc. The train looks like floating in the air and the side walls of the angle brackets protect it from go off in to the wrong path.įig:5 Maglev track with guides Fig:6 Maglev Train/Car Now the last question is “how we run this maglev train forward? Now place this rail board arrangement in a smooth horizontal exterior and then place properly the maglev train over the rail tracks. After peeling the plastic coating from the long magnetic strips of 24", place them in the flat portion of the plastic guide rails. Similarly, place another plastic guide rails in the same manner as shown in figures.Ĥ. ![]() for securing the rail at this proper position. First place the angle brackets or plastic guide rails on the board and it should be aligned in such a way that its edge should be placed with the ‘line 1’ and the flat portion of the guide rail will cover the ‘A line’. ![]() These lines A&B, used as the guidance for the magnetic strips.ģ. Now draw two more lines (line A & B), as shown in the figure 3, which is 1/8" outside the line 1&2. This is the line where we mount the plastic guide rails.Ģ. First draw two lines parallel to each other having length 24" and 1/4" apart each other (say 1&2). This will act as a protective wall for the maglev train from move off to the rail.ġ. Properly mount the plastic guide rails or side rails on the edges of the long magnetic strips as shown in the figure 1 & 2 shown below.Fix them 1/2" apart on the large wooden box or card board.Similarly peel the plastic coating from the long magnet too. ![]() This act as the wheels of the maglev train model.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |